Shop  Projects
RC UAV PLANE :
Ford GT500 :
2011 Ford Raptor 6.2 L
2009 YAMAHA FZR
HONDA  F-15X
Parts List :

Riva Intercooler Kit
E tech  SC Wheel
R Rated 500cc Injector Kit
R Rated Air Intake Kit
R Rated Free Flow Exhaust
Skat-Trak Prop
R-D Ride Plate
R&D Intake Grate
Riva Intake Spacer
R&D R3 Reflash
Top Speed :    82.7 MPH ( in tuning )
Parts List :

R Rated ECU
R Rated Air filter kit
R Rated Race Exhaust
R Rated Trim Ring
Custom Seat cover
2011  YAMAHA FZS
We will be starting with the basics for speed and handling . All PWC,S built at R Rated Performance  are built to be reliable ! We have had years of Endurance Racing and we have learned the fastest ski doesn't always win !  We have raced in races up to 4 hrs and reliability is key ! Also if you are using it for rec riding nobody likes to break down .
R&D Race Filter Very clean set-up and flows very nice !
Stock Speed : 65.7 on GPS the stock Speedo on the gauge was around 70mph  This was with the ski having 2 bars of fuel and only 3 hrs on motor .
First we would like to thank Toms River Yamaha for letting us grab one of the last Fzs  from there stock , And letting us grab a rear FZR seat set-up . First we removed the foam from the side panels that restricts the air flow and we remove the nice engine cover .
Next we installed a R Rated Performance Air intake and a       R Rated Free flow Exhaust kit .
STOCK EXHAUST.
Free Flow kit
After installing the parts it was out on the water again !                              Top Speed GPS  67.5   These parts helped out a little but when we do more mod's to the motor is when these parts will help even more . Also they almost removed over 12 Lbs from the ski and made more room in the bilge .
2011 Yamaha FZS
with a FZR seat assy

Mirrors removed and
waiting for seat cover
Ok now with  :
R Rated Air intake  , R Rated free flow exhaust  , Riva Stainless intake grate and Riva Ride plate , Ribbon delete in manifold , 

We GPS the ski at same fuel level and Top speed was 69.8   While we were out on the water We switched the ECU With a R&D Reflash Speed Would be Allot faster if we installed a C1 supercharger Wheel but we are trying to see what it will do with not touching the motor YET !  With the R2 reflash the ski went 72.0 with 5 speed runs .
We Just installed a MOTEC ECU into the ski  !  The purpose of this is so we can monitor the complete engine while we design new parts for the ski . Like GPS ,  extra temp sensors for a custom intake manifold and intercooler .  First test will be with the motec just as the ski sits to get a base line speed and record engine data before mod's start !